SEARCH
Contact Us
Damage Condition Possible Causes Countermeasures
Creep is the phenomenon in bearings where relative slippage occurs between fitting surfaces and thereby creates a clearance between them surface. Creep causes a shiny appearance, occasionally with Scoring or Wear.
  • Insufficient interference or loose fit
  • Insufficient sleeve tightening
  • Check the interference, and prevent rotation
  • Correct the sleeve tightening
  • Study the shaft and housing precision
  • Preload in the axial direction
  • Tighten the raceway ring side face
  • Apply adhesive to the fitting surface
  • Apply a film of lubricant to the fittingsurface

 

Click a photo to enlarge it

Creep 1

Part: Inner ring of a spherical roller bearing
Symptom: Creep accompanied by Scoring of bore surface
Cause: Insufficient interference

Creep 2

Part: Outer ring of a spherical roller bearing
Symptom: Creep over entire circumference of outside surface
Cause: Loose fit between outer ring and housing

Downloads

Bearing Doctor

Guide to prevention and countermeasures for bearing failures

Consent

NSK uses third-party services that help us to improve our web site and show you more interesting content. In order to use these services, we need your consent. This can be revoked at any time. More information can be found here Link to privacy policy.